Motor & Engine Bay Looking Great! - Impala Tech
Rate this Entry

Motor & Engine Bay Looking Great!

Posted 08-25-2009 at 03:03 PM by BA.
Updated 09-04-2009 at 11:16 PM by BA.

You may recall that my main reasons for taking the engine out were to fix a crushed oil-pan and also to replace the clutch/pressureplate / pilot bushing.

Whew! I never thought it would take me 2.5 months but I did what I always tend to do. I had to clean things up and make them purty.

I broke out several cans of degreaser, brushes, kerosene, a putty-knife, sand-paper and probably a half dozen cans of spray paint.
I wasn't aiming for "show car",....just "presentable" and not embarassing. I'm very happy with how it turned out.






Views 2306 Comments 1
« Prev     Main     Next »
Total Comments 1

Comments

  1. Old Comment
    Since these pics were taken, I've eliminated the blue ground wire from the alternator and ran a new one to the header bolt. You can't even see it. Sweet!

    I also painted the top of the radiator with some semi-gloss. I had made it flat black from months ago when I thought I was going to keep the engine bay old/dirty looking. I needed to bring it up to current standards of the rest of the engine bay now.

    I still need to order an open element filter setup like someone else recently did (for a 2-barrel) and I still need to find my heater hose clamp/bracket for the passenger side wheel-well.
    Other than that, this area is done!
    permalink
    Posted 08-25-2009 at 03:11 PM by BA. BA. is offline
 
 
For the best viewing experience please update your browser to Google Chrome