Impala Tech - Reply to Topic
Restoration Corner Aimed at Originality

Thread: 1968 SS rear emblem locations Reply to Thread
Title:
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :
Post Icons
You may choose an icon for your message from the following list:
 

Register Now



In order to be able to post messages on the Impala Tech forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.

Password:


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:
OR

Log-in










  Additional Options
Miscellaneous Options

  Topic Review (Newest First)
01-22-2015 07:49 PM
gnfast87 Thanks Bill !

I went out and looked at the trunk lid. You are right. They filled in one hole with body filler and the other 2 were welded up. As you look up into the back side of the trunk panel there seems to be a long way to the top panel. I don't think a drill bit is going to be long enough to drill it out.

Hmmmmm, might have to think about this one.

B
01-18-2015 05:24 PM
62BillT Of course my advice is obvious, but just for the say so, check on the backside of the lid to see if you can see any bondo in the filled in holes. If there, carefully drill them out with a real small bit from the inside, then carefully drill them to size from the outside.

Bill
01-18-2015 01:53 PM
gnfast87 Thanks Don!

It's an original SS but the one emblem it didn't have was the trunk emblem. Don't know why.

It was recently painted so maybe they just filled the holes in.

thanks again,
B
01-18-2015 01:09 PM
68SS427 I have the 68 Fisher body manual. It does not the dimensions of the placement of the holes. But. no matter which emblem ( Chevrolet, Caprice, SS427 or Impala super sport) they all go in the same 3 holes punched in the lower right corner of the deck lid. If you look on the inside of that corner, there are pre-made access holes in the support frame to attach the retaining nuts of the emblem. If you don't have any holes showing on the outside, they must have been welded over or have Bondo filling them. you will see where the original holes were. Don S
01-18-2015 12:02 PM
gnfast87
1968 SS rear emblem locations

Which of the manuals would have the correct dimensions on where the rear trunk lid Impala Super Sport emblem would go??

I have the Assembly manual and haven't been able to find anything in it.

My guess would be the Fisher Body manual but I don't want to buy the wrong thing.

thanks,
B

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

 
For the best viewing experience please update your browser to Google Chrome