Impala Tech - Reply to Topic
Engine General Engine Discussion.

Thread: Long Block Question Reply to Thread
Title:
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :
Post Icons
You may choose an icon for your message from the following list:
 

Register Now



In order to be able to post messages on the Impala Tech forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.

Password:


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:
OR

Log-in










  Additional Options
Miscellaneous Options

  Topic Review (Newest First)
04-19-2019 06:19 PM
Big Dave
Quote:
Originally Posted by 68WASAGOODYEAR View Post
They do. I just wanted to ask what the best way of doing it would be.
Which is why I said to use the accessory bolt holes on the end of the heads.

Big Dave
04-19-2019 05:41 PM
68WASAGOODYEAR They do. I just wanted to ask what the best way of doing it would be.
04-18-2019 10:26 PM
BA. Do your alum. heads not have accessory drive bracket bolt holes?



Sent from my XT1254 using Tapatalk
04-18-2019 05:12 PM
68WASAGOODYEAR Normally I would hoist it using the intake bolts, but this is a long block and there is no intake installed. I need to get it out of the truck (rental) and into my garage, so I don't have time to install the intake and don't want to be rushed either. I'm guessing 3/8-16 for the head bolt bosses like pretty much everywhere else on a BBC?
04-18-2019 02:55 PM
Big Dave Use the bolts on the front and back of the heads instead of the intake manifold face. Chain could divot the front face where you are trying to seal the intake resulting in a water leak or a vacuum leak. On the head a dimple will not interfere with anything later.

No need to retorque head bolts.

I use a steel plate bolted to the carburetor flange on the intake manifold to remove or install a motor. I would rent or buy a cheap (1,500 pounds) engine hoist to pull and install the motor if you don't already have one. I used to use a five ton hoist because it had an air over hydraulic pump to lift motors and was as stable as the rock of Gibraltar (but it got sold with the shop when I retired from engine building).

Big Dave
04-18-2019 02:35 PM
68WASAGOODYEAR
Long Block Question

This is probably a dumb question, but I'm going to ask it anyway - better safe than sorry. Are there any special precautions I need to take when moving a long block 496 with aluminum heads around with a hoist? I will have to lift it by the heads (hoist chains attached to the intake flanges) to get it out of the truck (I don't have a forklift). Do I need to retorque the head bolts afterward? Protect the intake flanges on the heads?

Never had a BBC with aluminum heads before. Don't want to damage it either. Thanks for any replies.

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

 
For the best viewing experience please update your browser to Google Chrome