Impala Tech - Search Results
Advanced Search
Showing results 1 to 25 of 89
Search took 0.01 seconds.
Search: Posts Made By: 69427
Forum: General Tech   11-21-2006, 10:31 PM
Replies: 5
Views: 6,615
Posted By 69427
you could allways just cut 1/2 to a full coil of...

you could allways just cut 1/2 to a full coil of your existing springs ? but it's not an exact science, well it is but you have to be good at math.
if you have the time and patience start with half...
Forum: Wheels & Tires   11-21-2006, 10:25 PM
Replies: 2
Views: 2,327
Posted By 69427
I had 8 inch ralleys 4-1/2 inch backspace on the...

I had 8 inch ralleys 4-1/2 inch backspace on the front with 235 x 75 x 15 on the front, lowered 2 inches all round, only just rubbed on the inside on full lock
Dave
Forum: Engine   08-02-2006, 03:08 AM
Replies: 2
Views: 2,066
Posted By 69427
see driveline section

see driveline section
Forum: Transmission & Driveline   08-02-2006, 03:06 AM
Replies: 1
Views: 3,533
Posted By 69427
C7E02D = powerglide built in Cleveland May 2nd...

C7E02D = powerglide built in Cleveland May 2nd 1967 day shift
3863192 = extention housing casting number is correct for 65 on
It will bolt up o.k. providing it's a T350 your pulling out not a T400...
Forum: Interiors   08-01-2006, 02:00 AM
Replies: 16
Views: 4,344
Posted By 69427
I've seen 65s & 66s with a second ashtray on the...

I've seen 65s & 66s with a second ashtray on the far right side, but not right next to the heater & air cond. controls, but who knows ? it may have been an option or a factory @#$% up, but you're...
Forum: Interiors   07-31-2006, 12:20 AM
Replies: 16
Views: 4,344
Posted By 69427
2 ashtrays ? mmmmm maybe ? this is the correct...

2 ashtrays ? mmmmm maybe ?
this is the correct console ( eBay item #290011377698 )
this is the correct gage cluster ( # 250010704475 )
there's also a red convertible on ebay with console and gages...
Forum: Transmission & Driveline   07-29-2006, 07:59 PM
Replies: 2
Views: 2,462
Posted By 69427
a stage one shift kit isn't a bad idea, it...

a stage one shift kit isn't a bad idea, it shouldn't bang into gear behind a 283, it will
prolong clutch and band life and it it'll take that typical p/glide gear change lag out of it
dave
Forum: Interiors   07-29-2006, 07:54 PM
Replies: 16
Views: 4,344
Posted By 69427
attach a couple of photos, factory air ? or...

attach a couple of photos, factory air ? or dealer installed under dash ? I've seen air cars with gages so I know they fit, maybe an incorrect gage housing, different console for gages ? or you may...
Forum: Troubleshooting   07-27-2006, 02:38 AM
Replies: 4
Views: 2,786
Posted By 69427
could be the wrong proportioning valve in the...

could be the wrong proportioning valve in the master cylinder, or wrong proportioning block for that master cylinder, maybe still poor vacume, big cam ? could still be a leak, try a new hose from the...
Forum: Restoration Corner   07-25-2006, 03:40 AM
Replies: 1
Views: 1,444
Posted By 69427
stop looking ! yeah right. I found a set....

stop looking ! yeah right. I found a set. thank you eBay.
dave
Forum: Restoration Corner   07-25-2006, 03:37 AM
Replies: 2
Views: 1,892
Posted By 69427
I also found this site...

I also found this site http://www.stencilsandstripes.com/pr_misc_wga.asp
hope this helps
dave
Forum: Troubleshooting   07-25-2006, 03:28 AM
Replies: 5
Views: 3,225
Posted By 69427
hope it's still under warranty ? @#$%ing...

hope it's still under warranty ? @#$%ing computers !
dave
Forum: Bench Racing   07-18-2006, 06:05 PM
Replies: 10
Views: 2,666
Posted By 69427
GTOs are imported to the U.S, but not for long,...

GTOs are imported to the U.S, but not for long, GMs attitude has changed recently, the word is, from Lutz himself, that most exisiting mid and full size GM platforms will be replaced by "zeta" a...
Forum: Bench Racing   07-18-2006, 04:54 AM
Replies: 10
Views: 2,666
Posted By 69427
future impala ?

2007 - 2008 impala may be based on this

http://www.vecommodore.com.au/ss-v/

I reckon that would sell ?
Forum: Restoration Corner   07-18-2006, 03:31 AM
Replies: 2
Views: 1,892
Posted By 69427
check this site out ...

check this site out
www.1969chevy.com/wagons.htm (http://www.1969chevy.com/wagons.htm)
dave
Forum: Transmission & Driveline   07-18-2006, 02:42 AM
Replies: 2
Views: 1,699
Posted By 69427
I agree with tom, I would assume, whoever...

I agree with tom, I would assume, whoever installed the "hurst" shifter put the reverse linkage in upside down, even super T10s have the same pattern, should be an easy fix.
dave
Forum: Restoration Corner   07-18-2006, 02:38 AM
Replies: 1
Views: 1,444
Posted By 69427
vinyl roof moulds

does anyone out there know where I can find a set of chrome or stainless mouldings that finish the edge of a vinyl top around the quarters and rear deck of a 69 impala sport coupe (in any condition)...
Forum: General Tech   07-11-2006, 06:13 PM
Replies: 9
Views: 2,494
Posted By 69427
I agree , all of the above have worked for me...

I agree , all of the above have worked for me when buying a car,
you can also try and use the "four door not as desirable" aproach
but don't fall for the "I've got someone else interested " it's...
Forum: General Tech   07-11-2006, 02:24 AM
Replies: 9
Views: 2,494
Posted By 69427
that's kind of a hard one, if it's real nice...

that's kind of a hard one, if it's real nice (nothing to do) well....maybe
http://www.bcautos.com/musclecars/impala62.html
I found this coupe for the same money, not as original and probably not...
Forum: Restoration Corner   07-09-2006, 06:13 PM
Replies: 7
Views: 1,944
Posted By 69427
I've never seen one in the flesh, on the web or...

I've never seen one in the flesh, on the web or in any book or magazine I've read in 25 years but anything's possible
dave
Forum: Wheels & Tires   07-09-2006, 03:25 AM
Replies: 3
Views: 2,513
Posted By 69427
yeah I've seen that neat little wheel gage...

yeah I've seen that neat little wheel gage somewhere too ? where ? I dunno now, old age !
try this www.earlywheel.com/choosing.html (http://www.earlywheel.com/choosing.html)
you can fit pretty big...
Forum: Bench Racing   07-09-2006, 03:10 AM
Replies: 10
Views: 2,666
Posted By 69427
I feal sorry for any HP officer that has to...

I feal sorry for any HP officer that has to pursue someone in a FWD impala, like they need another challenge, now they'll have torque steer trying to rip the wheel out of his hands too !
dave
Forum: Bench Racing   07-07-2006, 01:14 AM
Replies: 10
Views: 2,666
Posted By 69427
the holden "caprice" is a loaded and stretched...

the holden "caprice" is a loaded and stretched commodore, the only thing in common with Chevrolet is the engine and trans.
it's available in Australia, Asia, and Africa in RHD and the middle east...
Forum: Site Discussion   07-05-2006, 06:43 PM
Replies: 1
  New guy
Views: 1,523
Posted By 69427
welcome Steve, nice collection, this site is...

welcome Steve, nice collection, this site is still in it's infancy so be patient, but most questions will get aswered eventually.
dave
Forum: Brakes & Suspension   07-05-2006, 06:38 PM
Replies: 2
Views: 1,703
Posted By 69427
I'm pretty sure any full size chevy, pontiac,...

I'm pretty sure any full size chevy, pontiac, buick or olds use the same park brake assembly from 65 to around 70 so ring around a few junkyards or eBay, or you can try a stronger release spring,...
Showing results 1 to 25 of 89

 
Forum Jump
 
For the best viewing experience please update your browser to Google Chrome