Impalas.net banner
1 - 12 of 12 Posts

·
Registered
1964 Chev Belair was a 230 now has a 250 from a 75 Nova
Joined
·
7 Posts
Discussion Starter · #1 ·
Hello all.
I have a 64 Belair with a 230, replaced the engine with a 250 from a 75 Nova. Now that the engine is in it looks like the transmission is on a slight angle? I am not sure if it was like that before? The motor mounts feel into place and so did the transmission mount bolts and hanger bearing bolts.
I think that the transmission pan was level before I pulled it all, but can't remember 100%.
 

·
Registered
Joined
·
1,317 Posts
What kind of Transmission do you have?
 

·
Registered
Joined
·
1,317 Posts
Is your Engine angled too? Or just your Trans?
 

·
Registered
1964 Chev Belair was a 230 now has a 250 from a 75 Nova
Joined
·
7 Posts
Discussion Starter · #10 ·
After hours of looking searching and looking more I found the issue!!! Please be kind when I say what it was.
🤦🏼🤦🏼🤦🏼🤦🏼🤦🏼🤦🏼🤦🏼🤦🏼🤦🏼🤦🏼🤦🏼🤦🏼🤦🏼🤦🏼🤦🏼🤦🏼🤦🏼🤦🏼🤦🏼🤦🏼🤦🏼🤦🏼🤦🏼🤦🏼🤦🏼🤦🏼🤦🏼🤦🏼🤦🏼🤦🏼🤦🏼🤦🏼🤦🏼🤦🏼🤦🏼🤦🏼🤦🏼🤦🏼🤦🏼🤦🏼🤦🏼🤦🏼🤦🏼🤦🏼🤦🏼🤦🏼🤦🏼🤦🏼



right side motor mount bolt wasn’t in theframe motor mount. 🤦🏼🤦🏼🤦🏼🤦🏼
 
1 - 12 of 12 Posts
Top