Impalas.net banner

1 - 1 of 1 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
Hello Team Impala,
Thanks for the post. Does anybody have the correct length of the powerglide and the correct length of the driveshaft and front yoke used for my application. 1966 Impala pg and 327 car. Engine trans and shaft are long gone. 1) ( bell housing flange to output shaft seal flange) and 2) ( center of front u joint yoke to center of rear u joint yoke) 3) (center of front u joint yoke to tip of yoke) all three measurements.

Thanks, Fred
 
1 - 1 of 1 Posts
Top